 How do I allow a Sipura SPA to directly call a SPA3000 to use it's PSTN line?
|
| Let us assume that both units are on the same subnet. For this example, we will assume the other SPA is a SPA-2000. The SPA3000 has an IP of 192.168.0.3 and the SPA-2000 has an IP of 192.168.0.200.
On the SPA3000, under the PSTN Tab, configure the following:
VoIP-To-PSTN Gateway Enable: Yes
VoIP Caller Auth Method: HTTP Digest
One-Stage Dialing: Yes
VoIP User 1 Auth ID: My-username
VoIP User 1 Password: My-password
VoIP User 1 Dial Plan: None (which means no restrictions)
PSTN-To-VoIP Gateway Enable: Yes
PSTN Caller Auth Method: None
PSTN Caller Default DP: Y
Dial Plan Y: (S0<:My-username@192.168.0.200>)
PSTN CID For VoIP CID: Yes
The above dial plan forwards the incoming PSTN call alr
On the SPA-2000:
Proxy: 192.168.0.3:5061
Register: No
Make Call without Reg: Yes
Receive Call with Reg: Yes
UserID and Password: My-username and My-password as defined on SPA3000
When a call is made from the SPA-2000, you will get a ring and a second dialtone, the call will go mute while touchtones are being sent to the PSTN line.
| Contributors: |
Created by eric, August 10th, 2007 at 04:36 AM
Last edited by eric, August 10th, 2007 at 04:36 AM
0 Comments
, 1343 Views
| | | |
Similar Threads for: How do I allow a Sipura SPA to directly call a SPA3000 to use it's PSTN line? 
Linear Mode
