[sipcpe]

For those with a Sipura or other unlocked two port gateway:

1. Plug the t-adaptor into the port on your Sipura with the unlimited voip service (say Braodvoice), then connect one line from the t-adaptor to the FX-200 PSTN port the other line to your phone.

2. Set the Transit In switch to OFF so these calls will only ring the phone connected to this port on the Sipura via t-adaptors.

3. Then plug the other port/service on your Sipura (say FWD) into the VOIP port on the FX-200.


All your Broadvoice calls will flow as normal and not be answered by the FX-200 but only ring the atached phone and should go to voice mail if no answer.

Your FWD calls will be answered by the FX-200 and transfered to your Broadvoice port and you can make your long distance calls through your Broadvoice service. With your FWD service and a Virtual Line (free in some cases) you can now access your Broadvoice Service remotely either through the internet via a softphone or via the pstn via the virtual number.

Note: you may have to play with the tuning proceedure and the sipura's input gain control to get the disconection to work properly and be aware any FWD calls that come in while your are otherwise engaged on the
Broadvoice phone line will be merged or conferenced automatically.

[MarcelProust]

Can you do it with SPA3000 without FX-200?

[mberlant]

Yes. If you have two VoIP services that you want to bridge, and don't have any POTS lines you need to add to the mix, you can simply strap the Line and Phone jacks to each other. There are several threads here on Voxilla that discuss this configuration.

[franktarz]

Can you use a FX-200 WITH a SPA3000 to get VOIP to VOIP bridging and a POTS line?

[sipcpe]

We have not tested this cdonfiguration