[djw]

I'm still a learning but I purchased a dph-140s to test with AAH 1.5. I
think this is a rebadged ACT P104SLD which others seem to have working with aah. It seems to be configured and registered similarly to the softphones I've been using without problems, but it does not receive or send audio (it will send audio to vm oddly enought), and won't perform the loopback test. It seems to signal and receive calls fine. The phone is on an internal lan with a local aah server.

I'm merely guessing but it seems like the rtp side is not communicating
properly? The codec selected is ulaw as in the config, I changed what they call "media" port from 41000 to 10000, to no avail. Does anyone have a fully working dlink or ACT P104SLD phone with aah, or particularly this model? It seems very close to working, but I'm stumped.

The puzzing thing to me is you can never hear any audio (tones are ok), and the audio is heard in a vm message. The phone is pretty decent otherwise so any tips would be appreciated.

[djw]

It's working fine now. My guess is silence suppression was the problem.

[jeffik]

Hi, i too have a p104sld. It worked fine for 3 weeks. Now it will not log on. I have done factory reset through the web interface but still will not log on. I see activity on the router. When i try to make a call i get one busy tone and Disconnect on the display. I sent an email to ACT but so far no reply. I am wondering if there is a way to either reflash the firmware or do a hard reset from the phone itself. Any ideas? Thanks in advance.