[Maverick1]

Hi Guys.

I have a SPA9000 Hardware V 1.05, Firmware 3.3.6 went through the whole 1.05 vs. 2.0 Linksys Fiasco, and after a few hours figured out that I need the 9000t firmware.

The problem, is no matter how I do the upgrade, it doesn't work. I tired the 5.1.7, 5.1.8, 5.1.9 Firmware, I tried using the wizard, the .exe loader, and even tftp to upload the Firmware but it just doesn't work.

The wizard connects, tells me it sees the SPA9000, Firmware 3.3.6, and then tries for about 15 seconds, and then comes back and says "Failed to Upgrade. Check your network connection or device type."

The .exe Firmware loader says "Upgrade Failed: No response from SPA"

The TFTP loads, does not error, but the result is no firmware change.
Using http://<SPA 9000's IP>/admin/upgrade?tftp://<Computer IP>/spa9000-5-1-6a.bin

When I try loading the Ver 1 Non-T firmware, I get a incompatible device error, so I have pretty much ruled out Rev 1 Firmware.


So my question is ? Is there some order path of firmware upgrades? Do I have to load 5.1.0 First ? Before I can load 5.1.9 ?

Any ideas here ?

[priller]

I recently upgraded directly from 3.3.6 to 5.1.9 via the .exe loader. Oh ya, the whole hardware version 1.0.5 really means v2 was entertaining for a while.

Have to ask .... Did you ensure that "Upgrade Enable" = Yes ... that's on the Voice --> Provisioning page.

[Maverick1]

Yah, I did.

I even set it to NO, and tired the Firmware upgrade, and then I set it back to YES, and tired again. Still no go.

Thanks for the thought though.

[griadmin]

Does the SPA9000 have the default account and password configured. I had issues until I went back to default account and passwords for upgrades.