[jpennell]

So far, no random call disconnection issues... and UK CID back again! Outgoing calls seem OK too.

In respect of the random call disconnects...

"Selecting "UK BT" CID method causes random DSP errors after 2-13 min call duration, causing the calls to disconnect. Resolved. Related defect - CSCso28510"

[Simon2007]

Hi, just thought I would add my feedback to help others considering 1.0.1.4 as I have upgraded to this version.

I am very pleased to say that I have not experienced any dropped calls yet, but unfortunately I do get a few anonymous caller rings after every incoming call has hung up. (the few anonymous rings was something I experienced in version 1.0.1.3)

Has anyone else upgraded and experienced this additional ring issue with 1.0.1.4 ?

Regards


Simon

[jpennell]

I have never had the false ring provided that "number of rings before answer" is at least 2 - in fact, in 1.0.1.4 there is a note to that effect by this setting.

J

[coolfish]

Simon2007,

The new 1.0.1.4 firmware also mandates that the "wait for answer time" be no less than 100 seconds. We had it set to a lower value in an earlier firmware release and experienced phantom calls after hanging up from a real call. Setting it to "100" resolved that problem. We also experienced similar issues when attempting to set the "Answer After" value to a values less than 2 (as per jpennell's comment above) in earlier firmware releases.

So far so good with 1.0.1.4 on the SPA400 though.

[Simon2007]

Thank you jpennell and coolfish!

It was the number or rings before answer. Ours was set to 1 and must admit we didnt spot the two notes on the SPA400 voice tab config page before.

Now all appears OK!! thanks.

Regards


Simon