[bdwnnc]

Both Stanaphone and FWD register: FAILED

I can dial out through Line 1 (SBC POTS line).

Surfboard modem>Netgear MR814 router>SPA3000
Upgraded SPA3000 firmware to 2.0.13(GWg).
Dial plan: Voxilla default

Line 1 - Stanaphone
Line enabled: yes
NAT Mapping Enable: yes
Nat Keep Alive: $Notify
Proxy: sip.stanaphone.com
Register: yes
Register Expires: 60
User ID: 914*******
Password:********
Use Auth ID: no

Gateway 1: 628***@fwd.pulver.com
GW1 Auth. ID: 628***
GW1 NAT Mapping Enable: yes
GW1 Password:*********


PSTN Line - FWD
Line enabled: yes
NAT Mapping Enable: yes
Nat Keep Alive: $Notify
Proxy: fwd.pulver.com
Outbound proxy: fwdnat.pulver.com:508
Register: yes
Register Expires: 180
User ID: 628***
Password: same as GW1 password.
Use Auth ID: no

This will be the first of many questions, any help will be appreciated.[/b]

[mjy78]

Have you forwarded port 5060 to the internal IP address of your SPA3000 in your router's NAT configuration?

[bdwnnc]

No. I have not touched the router, any suggestions?

[bdwnnc]

Port forwarding? DHCP Server? Dynamic DNS?
The router jargon is rather foreign to me.

So this is what I found under PORT FORWARDING:
Netgear Custom Services

Ports - Custom Services

Service Name - FTP, HTTP ???
Starting Port - I'm guessing....5060?
Ending Port - no idea!
Server IP Address - would that be SPA3000 LAN IP?

[mberlant]

I wouldn't advise forwarding any ports except as a last resort. Even then, I would try to avoid it.

Have you configured a STUN server on your 3000? Have you also enabled NAT resolution on each Line? For a STUN server I recommend stun.fwdnet.net:3478 and stun.softjoys.com:3478.

[bdwnnc]

Mberlant

I read your 01/18/05 post from 'port 5060 and 5084 blocked', thx for the clarification. I have not port forward 5060.

A couple of questions:
I enabled Stun server and stun test (SIP), then entered stun:softjoys.com:3478 to STUN server, resulting in Line 1 changing from FAIL to NOT REGISTERED (PSTN Line reads: NOT REGISTERED). Is this correct?

If Line 1 - Stun server information is correct, where do I input stun.fwdnet.net:3478 information?

I am unclear on NAT resolution enablement on each line.