SPA 3000 w/ sipphone registration fails

[slick123]

I have the original Sipura SPA 3000 with stanaphone. As stanaphone discontinued their service, I am trying to setup with gizmo/sipphone. I created a gizmo account which gave me sip number.
I left most of the setting as is from stanaphone but just modified the following. I am wondering if somebody can tell me if they are wrong.

Under Line tab I am using following:
SIP Settings
SIP PORT:5060
Proxy and Registration
Proxyroxy01.sipphone.com

Subscriber Information
User ID:17474051716
Password: xxxxxx
Gateway Accounts
Gateway 1:17474051716@proxy01.sipphone.com
GW1 Auth ID:17474051716
GW1 Password::xxxxxxx

Under SIP tab
NAT Support Parameters
STUN Server:stun01.sipphone.com:3478

I am not sure if I am missing anything. In the gizmo/sippone account I didnt buy any call in/call out numbers.....I just want to see if it works. The registration in SIPURA says failed..also
when I call the gizmo access number +1 + SIPNUMBER, it rings one time and then I get email with VM.

I would appreciate it if anybody can point me in the right direction.

[aa6rr]

See this post and try my sip settings:

http://forum.voxilla.com/linksys-sip...zmo-32118.html (SPA 1001 and Gizmo)

[slick123]

Thanks for your help. I think I have similar setting as you. Could you share your gateway accounts information. I listed the gateway information in my posting above. I was using port 5060....I changed it to 5061 and I am still getting "registration failed"...The sipura is behind router...is there any setting I need to make for port 5061 in it?

[aa6rr]

Unfortunately, my SPA3000 is locked (courtesy of Broadvoice). I am using a SPA-2002 for Sipphone, which does not have a PSTN gateway . I believe that the SPA-3000 only supports 1 "incoming" voip account, so I assume that you are only trying to configure just 1 account (sipphone). Have you tried resetting the unit, entering just the sipphone parameters for Line 1 and no gateway, filling in the stun server info ? I used port 5061 only because I had Broadvoice on 5060. I have absolutely no mods done to the router to make Broadvoice, Sipphone and Free World Dialup work together. It is a Linksys BEFSR81 8 port router. If all else fails, you could purchase a different ATA off of Ebay (?) By the way, you do not need to purchase anything from Gizmo for the line to "register". It is always a good idea to either bypass your router when possible or atleast put the ATA in the DMZ while you are troubleshooting a registration failure.