[adam71o]

At 33 minutes into this video ..
http://revision3.com/systm/asterisk
they setup Asterisk and the SPA3000 so that any number dialed on the FXS port plays the monkey sound, AND they get the monkey sound to play for any call coming in on the FXO port (PSTN).

This, ofcourse, is only for the purpose of testing to make sure both ports on the SPA3000 get into Asterisk.

My SPA3000 has the latest firmware.

Right now, on my setup, I have an analog phone plugged into the FXS port on the spa-3k (SPA3000), and the FXS port is enabled, but the FXO port is DISabled. With this setup, any number dialed on the phone plugged into the FXS port gets the monkey sound. BUT --- if I just enable the FXO port, then the FXS port does not get the monkey sound after dialing a number. SO, it seems that ENabling the FXO port, in my case, is causing a problem on the FXS port.

Here are the applicable parts of the conf's:

sip.conf

[sipura1FXS]
  type=friend
  context=sipura1FXS
  secret=password
  host=dynamic
  dtmfmode=rfc2833

[sipura1FXO]
  type=friend
  context=sipura1FXO
  secret=password
  host=dynamic
  dtmfmode=rfc2833

extensions.conf

[sipura1FXS]
  exten=_X.,1,Answer
  exten=_X.,2,Wait(2)
  exten=_X.,3,Playback(tt-monkeys)
  exten=_X.,4,Hangup

[sipura1FXO]
  exten=_X.,1,Answer
  exten=_X.,2,Wait(2)
  exten=_X.,3,Playback(tt-monkeys)
  exten=_X.,4,Hangup

With the FXO port disabled on spa-3k, this is what the "INFO" tab says:


When I enable the FXO port, this is what the INFO tab looks like (again, this is when I can no longer dial a random number on the FXS port and get the monkey sound) :




I'll also note, that after enabling the FXO port, I can dial in on it and it will answer, stay silent for ~10 seconds, then hangup.

Here is my Line 1 configuration:


...and here is my PSTN configuration:


Is it possible that I have a bad piece of hardware, or is is the (more likely) case that I do not have something configured correctly?
If (hopefully) I have just done something wrong, can someone point me in the right direction?

Thank you so much!
-Adam

[adam71o]

Oh this isn't good. Regardless of any of the configs listed above, has anyone seen the FXS port operate differently when the FXO port is enabled, vs when the FXO port is DISabled?