Voxilla VoIP Forum

silasgtthomas · #1 (**permalink**) January 13th, 2007, 12:50 AM

Ok... so I got my Cisco 7940 updated to sip, I even got it to download the config from the Broadvoice TFTP server, even shows the broadvoice logo, I got dial tone, but I'm not getting incoming calls, and dialing out results in a busy signal.

Anyone got any ideas?

Any help is greatly appreciated!!!!

Thanks!
Silas

portalsystems · #2 (**permalink**) January 26th, 2007, 01:37 AM

What version of the firmware are you using?

You have to use SIP 7.4 for Broadvoice to work.

I was having the same issue and then downgraded from 8.2 to 7.4 and it worked.

Hope this helps.

Dave
Portal Systems

tkanwar · #3 (**permalink**) February 22nd, 2007, 02:43 PM

I have the smae problem. It was working fine and am on P0S3-07-0-00. can anyone send me the SIP 7.5 version

User Name		Remember Me?
Password
No account yet? Create one
Forgot your Username or Password?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads for: 7940, updated to sip, dial tone, logo, but no calls
Thread	Thread Starter	Forum	Replies	Last Post
7960/7940 SIP IP phone	prajothpj	Other Hardware/Software	0	January 2nd, 2007 07:57 AM
SPA3102 - dial tone from Line1 but cannot calls not completing	jturver	Linksys (Sipura) VoIP Support Forum	1	December 14th, 2006 12:41 PM
UPDATED - UK PSTN Disconnect Tone	Black20VT	Linksys (Sipura) VoIP Support Forum	2	June 6th, 2006 08:06 PM
Cisco 7940 SIP not visible	Erich.B	Other Hardware/Software	0	March 3rd, 2006 09:20 AM
DIAL TONE OK BUT UNABLE TO MAKE PHONE CALLS	Kukulut	BroadVoice Support Forum	5	June 3rd, 2005 11:37 PM

Voxilla VoIP Forum

7940, updated to sip, dial tone, logo, but no calls